Alone or assisted with water, plasma has proven itself to be one of the most efficient cutting processes for sheet, plate, tube, pipe, and profiles. Search this technology area for information on equipment, cutting tips, and gases.
September 16, 2008
Plasma cutting is one of the most efficient ways to cut sheet and heavy plate, but that efficiency can evaporate quickly without proper consumable maintenance.
August 27, 2008
Kaliburn has announced the expansion of its Spirit product line to include 150a and 200a models. The new systems—one a 150-amp model, the other a 200-amp—are automated high-definition...
July 15, 2008
Thermal Dynamics has introduced the AirCut 15C manual plasma cutting system, which is suitable for HVACR applications.The 29-lb. system, which has a built-in air compressor, cuts up to 3/16 in. with a...
July 15, 2008
Koike-Aronson Inc., Arcade, N.Y., recently installed AutoCut and UltraCut plasma cutting systems from Thermal Dynamics, St. Louis, at its training facilities in Arcade and Houston. Koike trained all...
June 17, 2008
AKS Cutting Systems has introduced the tru-kut heavy-duty, 5-ft. by 10-ft. plasma cutting system. The rigid, fully welded steel frame provides a stable platform, the company reports.Single setup...
May 13, 2008
ButlerBuilt, a leading manufacturer of motorsports seating located in Harrisburg, N.C., finds a new plasma cutting system to be a much better improvement over the 15-year-old plasma table it dumped in early 2007.
March 11, 2008
Denman & Davis calls itself the largest general-line, independent service center in the Northeast. The company has about 65,000 square feet of inventory and manufacturing space in Clifton, N.J., another 70,000 square feet in Slatersville, R.I., and another 35,000 in Albany, N.Y. The company distributes a variety of hot-rolled and cold-finished bars, structural shapes, sheets, and tubing, but has discovered a fruitful niche with plate, used in pressure vessel, power generation, and processing applications.