October 9, 2007
The 2007 FABTECH® International & AWS Welding Show, the largest North American showcase of metal forming, fabricating, stamping, tube and pipe, and welding equipment and technology, will return to...
September 11, 2007
The Bradbury Co. Inc., Moundridge, Kan., has announced two appointments to its engineering staff. The company has hired Mark McFetridge as a senior project engineering manager and Rex Stutterheim as a...
July 10, 2007
It would be an understatement to say that contract manufacturer EPMP Ltd., Seguin, Texas, got off to an inauspicious start. After just four years of operation, Ernest Plant sold the slumping company in 1988. This appeared to be just another short story of a failed start-up manufacturing shop....
November 9, 2004
Folding machines aren't the fastest machines for bending sheet metal, but for low- to medium-volume production, they can provide an efficient bending process. Because the equipment operator does not support the weight of the material during the bending cycle, folding machines are well suited to large, bulky parts. Also, part quality is not dependent on an operator's skill.
December 11, 2003
Schwenkbiegemachinen, or swing bending machines, have been in use for more than 200 years. European manufacturers began to power them with electrical or hydraulic power after World War II, when an enormous amount of sheet metal was used in the reconstruction of Europe.
March 13, 2003
The H.L. Lyons Co., Louisville, Ky., began 40 years ago as an X-ray equipment company in the basement of Keith and Livingston Lyons parents' house. It later became a general metal fabricating business.