http://www.thefabricator.com/OxyfuelCutting/OxyfuelCutting_TechCell.cfm The Oxyfuel Cutting tech cell is packed with specific links to help you find product information, suppliers, technical articles, case studies, seminars and conferences, as well as books, software, and videos on metal fabricating-related topics. en-us http://www.thefabricator.com/RSS/images/thefabricator_rss.gif http://www.thefabricator.com Copyright 2007 FMA Communications, Inc. All rights reserved. official publication date Tue, 21 Aug 2007 11:13:38 AM CDT Vicki Bell Laurie Harshbarger http://www.thefabricator.com/OxyfuelCutting/OxyfuelCutting_Article.cfm?ID=1156 Typical Oxyfuel Welding Setup Three distinct oxyfuel flames are used for welding, brazing, and cutting. The nature of these flames depends on the proportions of oxygen and fuel in the mixture. The flames are produced by the combustion of the oxygen and fuel gases and are called carburizing, neutral, and oxidizing flames. Fuel burning without oxygen resembles a common flame as seen in a blazing fire. This type of flame is not suitable for welding or cutting. When you light a candle, the ... John Uccellini Tue, 13 Sep 2005 12:00:00 AM CDT http://www.thefabricator.com/OxyfuelCutting/OxyfuelCutting_Article.cfm?ID=107 Research, development, and field experience have resulted in the evolution of reliable equipment and safe installation, operation, and servicing practices. However, accidents can occur when equipment is improperly used or maintained. Most safe practices are based on common sense, while others may require technical volumes to explain. The following tips will help you use your oxyfuel equipment properly and safely. Gas Cylinder Valve Gas cylinders always should be upright and fasten... Chet Strickland, Contributing Writer Thu, 10 Jan 2002 12:00:00 AM CST