Anthony McCue

AM Machinery Sales Inc.

Finishing | Articles | The FABRICATOR

Got burrs?

September 11, 2007 | By Anthony McCue

Using a machine to remove burrs from and put a surface finish on sheet metal and plate, also known as deburring and graining, is more complicated than it seems. The factors that go into selecting and setting up a deburring and graining machine are almost as numerous as the factors that cause burrs in the first place. Some of the important factors you have to consider are machine type (wet or dry), setup (the arrangement of sanding belts and deburring brushes), sanding drum hardness and diameter, brush type, and feed rate.

Continue Reading