BetaRam Inc.

John J. Pavelec

Vice President
BetaRam Inc.
P.O. Box 334
Troy, MI 48099


Phone: 248-853-0446
www.betaram.com
Contact via email

Tube and Pipe Production | Articles

Cutoff die setup for dimple-free rounds

December 13, 2005 | By John J. Pavelec

With the right equipment and proper setup, tube mills can produce dimple-free round tubing efficiently. A multistep process using a two shear blade makes a dimple-free cut, and an inline brush end finisher can be used to remove the ever-present clearance burrs, if needed

Continue Reading

Tube and Pipe Production | Articles

Tube mill cutoff die setup for square and rectangular profiles

September 13, 2005 | By John J. Pavelec

When properly selected and utilized, single-cut die sets can produce top-quality cut ends on square and rectangular tubing. This article discusses the criteria for selecting and using the die sets to achieve the best results.

Continue Reading

Tube and Pipe Production | Articles

Comparing single-cut and dimple-free tube mill cutoffs

October 25, 2001 | By John J. Pavelec

This article covers the application of single-cut and dimple-free cutoff shear technologies as they are applied to contemporary high-speed tube mills.

Continue Reading