-
- From The Fabricator
Try out, debug dies on-screen
Being able to try out and debug stamping dies on the computer screen represents a significant paradigm shift in die building and die tryout. Adding motion to the die as it is being designed and dynamic interference detection results in a less expensive, more profitable die.
-
- From The Fabricator
3-D die design for a 3-D world
3-D die design software allows you to build the die on the computer screen, fully assembled and ready to run as if it were built and sitting out on the shop floor. SolidWorks-based Logopress3 software even allows you to then simulate the die running in the press. Even better, it detects crashing and strip feeding interference problems on your computer screen rather than after the die has been built.
- Podcasting
In this episode of The Fabricator Podcast, Caleb Chamberlain, co-founder and CEO of OSH Cut, discusses his company’s...
