Selected articles from the July 2001 issue available online:

Know your bending basics—Part II

July 26, 2001

By:

When trying to make a good 90 degree bend with sheet metal, there's more than on way home. Just make sure your method can accommodate improvisation.

Continue Reading

Bend deduction charts

July 26, 2001

By:

Quite often I am asked, "Where can I get a bend deduction chart that works, one with valid numbers?" That's a good question.

Continue Reading

How to Kill a Robotic Project in Five Easy Steps

July 12, 2001

By:

How would you like to fail utterly in your quest to modernize your shop with robotic weldingequipment? Look no further—we've got all the bad advice you need right here.

Continue Reading

Abrasive jet diagram

Not your father's abrasive jet

July 12, 2001

By:

The advances made in abrasive jet cutting in recent years have negated much of the downside formerly associated with the technology.

Continue Reading