Selected articles from the October 2005 issue available online:

TIG welding - an overview

October 11, 2005

By:

Welding instructor Marty Rice explains the gas tungsten arc welding (GTAW) process, more commonly known as tungsten inert gas (TIG) welding.

Continue Reading

Die basics 101: Part IV

October 11, 2005

By:

Stamping dies can comprise many components. This article discusses the basic components, including die plates, shoes, die sets, guide pins, bushings, heel blocks, heel plates, screws, dowels, and keys. This article is one of a 16-part series on the fundamentals of stamping. Descriptions of all the articles in this series, and links to them, can be found at the end of this article.

Continue Reading

Welding robots and lean manufacturing learn to play together

October 11, 2005

By:

With careful analysis and planning, automation can be an integral, cost saving component of lean manufacturing.

Continue Reading

Successful tradeshow tips for attendees and exhibitors

October 11, 2005

By:

Getting the most from a tradeshow takes more effort than just being there. Following a few common tips, both attendees and exhibitors can maximize the tradeshow experience.

Continue Reading