Asma LLC Showroom

   Found 2 results for "Asma LLC"...

      Just show me: Everything | Articles | News | Products

Article

February 15, 2013

Finding the perfect die opening

Figure 1 These are the standard die shapes, though there are many other styles. Rolla-V, urethane, and “specials” are not addressed in this article. Bottom bending and coining “stamp” the inside bend radius into the part.... Read more...

Article

November 9, 2012

The basics of applying bend functions

Figure 1 The bend allowance calculation always uses the complementary angle. When a sheet metal part is bent, it physically gets bigger. The final formed dimensions will be greater than the sum total of the outside dimensions of... Read more...