Found 5 results for "Faccin"...
Just show me:
October 12, 2012
A plate rolling primer
This three-roll, variable-geometry system has a top roll that moves up and down, with bottom rolls that move side to side.
Jeff Visser remembers the day he was thrown to the wolves. He was a newbie plate rolling operator... Read more...
June 2, 2011
Plate rolls keep rolling heavier plate
Today’s machines are rated to cold-roll seriously thick plate. Here, a machine is being tested to roll 8-in.-thick plate cold. Some machines today have been built to cold-roll up to 11-in.-thick plate. Photo courtesy of... Read more...
March 1, 2010
Rolling for wind
Wind towers have gotten their fair share of coverage over the past few years. Much of what's made headlines involves the regulations and tax benefits that promote the technology. What isn't talked about as much is the actual design of the... Read more...
July 2, 2009
Rolling it just so
A precision operation at BEPeterson forms rolled sections to +/- 1/32 inch on circumference.
Walk onto the floor at BEPeterson (BEP) and nothing looks particularly out of the ordinary for a contract manufacturer... Read more...
April 6, 2004
New bends in the roll
Editor's Note: Allan Flamholz is now president and founder of Trilogy Machinery, Belcamp, Md., the U.S. distributor for ROUNDO in the U.S. as of July 2009. COMEQ Inc., White Marsh, Md., remains a source for roll bending equipment and expertise... Read more...