Found 5 results for "Victor Technologies International Inc."...
Just show me:
June 3, 2013
Plasma or oxyfuel?
Which process will ultimately yield the lowest cost per cut—oxyfuel or plasma—after all variables are considered? The basic nature of each process immediately dictates some choices when you are purchasing a new automated cutting table or... Read more...
March 4, 2013
Introduction to plasma marking
At a low amperage, plasma marking discolored the surface of this carbon steel part with minimum vaporization of the metal. A reduced marking speed will result in deeper penetration.
Fabricators mark parts to indicate part numbers, bend... Read more...
June 8, 2012
Choosing the right shielding for the best plasma cut
Fabricators have shielded plasma arcs with water mist for 30 years, but only recently has water shielding become viable for precision plasma cutting.
Over the years high-precision plasma cutting has advanced significantly.... Read more...
January 4, 2012
Heavy piercing with plasma
Today’s high-density plasma systems can cut quickly through thick plate, and certain technologies have made the initial pierce less of a challenge. Photo courtesy of ESAB Welding & Cutting Products.
Photographers... Read more...
March 10, 2009
You can plasma cut it, but can you weld it?
A lot happens in a plasma arc from its generation at the electrode surface to the workpiece. Among numerous other factors, the plasma forming gas and its surrounding shield material, be it gas or liquid, play a major role in the final cut... Read more...