Content tagged with "flanging"
Results: 4
Article
December 15, 2009
Sheet Metal Stamping 101, Part V
Editor's Note: This series presents an overview of metal stamping. Part I of this series focused on the various careers in the metal stamping industry. Part II discussed stamping materials and equipment;
Part III focused on dies and cutting and Part IV offered more detail about cutting... Read more...
Article
December 15, 2009
Sheet Metal Stamping 101
The author of the "Die Science" column in STAMPING Journal®, Art also has written several other series that appear at www.thefabricator.com, including:
Solving Punch Breakage Problems Die Basics 101 Cutting Tooling Costs
Read more...
Article
October 10, 2006
Drawing on new experiences
Press operator Brandie Watkins wipes down a refrigerator door before conducting a quality check. Appliance manufacturing has been due for a makeover for some time. As thousands of U.S. households have rediscovered home entertaining, they have sunk their hard-earned dollars into... Read more...
Article
August 8, 2006
Unique forming short cuts
Figure 1 The use of a 1-to-1 rocker ratio mounted beneath the forming section allows the metal to be formed both up and down, thereby twisting it. Die designers and process engineers often are faced with the challenge of making a part feature that is unique and possibly difficult to... Read more...
Didn't find what you were looking for? Try our search page to refine your results
