Press selection - sorting it out - Part IV
What Else Do I Need to Look for in a Press to Meet Demands for Increased Part Accuracy?
Matching Press Characteristics to Your Applications
The following questions—and their answers, provided by industry equipment manufacturers and experts—are intended as a general guide to help you simplify the daunting task of selecting a press or press system.
4. What Else Do I Need to Look for in a Press to Meet Demands for Increased Part Accuracy?
Part Accuracy—Frame Accuracy. "Part tolerance demands have become tighter, and zero defects are the norm. These demands have created the need for new press designs and very careful selection," Minster's Cattell said.
The more rigid the frame, the lower the deflection and vibration, and the more accurately the part can be made, press manufacturers said.
With new technology demands, the die designer often calls for a much lower total deflection with new press designs. A 0.001-inch-per-foot deflection is becoming the norm," Cattell said.
[Tip] Red Stag's Pfundtner said, "The JIS [Japanese Industrial Standard] accuracy inspection standard should be used to analyze press accuracy. This is a knife edge on the centerline under maximum force to determine the elongation of the press to the outside edge of the bolster."
Part Accuracy—Slide Guides. To improve part accuracy, the press must have low bearing clearance, close tolerances, slide guide systems, and wide-spaced connections as well as high rigidity, AIDA's Boerger said.
Part Accuracy—Servo. A servo-mechanical press's controllable slide motion allows it to adapt the slide speed to the requirements of the forming process, which can improve part quality, Schuler's Kinzyk said.
Part Accuracy—Hydraulic. A hydraulic press's control over forces and motions empowers the press to enhance overall quality of a manufactured part, manufacturers said. Control of lateral slide movement caused by off-center or unbalanced loads helps achieve tight tolerances and improves part quality.
STAMPING Journal is the only industrial publication dedicated solely to serving the needs of the metal stamping market. In 1987 the American Metal Stamping Association broadened its horizons and renamed itself and its publication, known then as Metal Stamping.